Running an entire Test Suite can be a time-consuming process. In some cases, the Test Suite might have both successful and failed Test Cases. After updating the failed Test Cases, you might want to run a test only for those Test Cases that have failed.
Whatfix enables you to re-run selected Test Cases to check if the Flow runs well or not.
Use the following process to re-run selected Test cases inside a Test Suite:
-
On the Whatfix Guidance dashboard, click Auto testing.
-
Click Test suites.
-
Click the required Test Suite.
Select the Test Cases you want to run the test for, using the checkboxes.
At the top, click Run test case.
Note:
To run individual Test Cases, hover your cursor over the required Test Case, and then click Run test case.
You cannot run individual Test Cases if Sequencing is enabled for the Test Suite.