Self Help does not display

Article summary

Did you find this summary helpful?

Thank you for your feedback

Issue

The Self Help tab does not display on the application.

Self Help may not display for one or more of the following reasons:

After a segment is created, it has to be explicitly made live by moving it from the Ready stage to the Production stage.

your title goes here

For more information on pushing widgets to Production, see Push Whatfix content and widgets to Production.

Check if you have content in Self Help.
Whatfix is configured to display the Self Help tab only if you have created at least one content unit that involves element selection. This means there should be at least one Flow in it.
Set correct Visibility Rules. For more information, see Visibility and Display Rule Conditions.

your title goes here

Incorrect Visibility Rules that are commonly used:

When you are adding more than one Visibility Rule, then ensure that the right operator is used.
Use And operator when the Self Help needs to be shown only when all the conditions are evaluated.
Use Or when the Self Help should be shown when any one of the rules is true.

Enable Preview Mode while testing.
Typically, you'd use the preview mode if you have not embedded the Whatfix JavaScript code. Here's how you can enable the Preview Mode on the Whatfix Studio.

your title goes here

If the issue persists, contact support@whatfix.com.

Was this article helpful?

Table Of Contents

Changing your password will log you out immediately. Use the new password to log back in.

Current password

New password

Confirm password

First Name

First name must have atleast 2 characters. Numbers and special characters are not allowed.

Last Name

Last name must have atleast 1 characters. Numbers and special characters are not allowed.

New email

Enter a valid email

Re-enter your password

Enter a valid password

Your profile has been successfully updated.

Logout